Method 3: Loads flash based user interface on any existing computer using FireFox 78.6.1 Follow step 4.

Method 2: Loads flash based user interface on any existing computer using FireFox Portable Legacy 68.

Follow steps 1 to 3(1-10) to implement Method 1.

Method 1: Loads flash based user interface on a Virtual Machine.

If any software interferes with implementing Method 2 or Method 3, then implement Method 1 as it makes sure that there is no other software blocking Flash on the machine. Please note that the user needs to disable anti-virus software for Method 2 and Method 3 as it is found that other softwares might interfere or block flash from running. There are three methods stated in this guide.

This article provides methods that use an older Adobe Flash Player and Firefox that will enable users to load Flash based Gocator user interface. If the user is unable to upgrade it due to system restrictions, they can follow any of the following methods to load the interface in 4.x firmware versions however, it is recommended to start with Method 2 or Method 3 first. Once upgrade is complete, go the IP address of the sensor and it should load with the upgraded firmware. dat file in your PC to upgrade the sensor. Click on the upgrade and navigate to the.

Load the page: and this should load a window with an upgrade option. As the user will not be able to load the interface due to flash blockage, the user can upgrade it by going into the rescue mode. One way to load the user interface is to upgrade Gocator firmware to anything above 5.3 version. Gocators firmware 4.x needs flash to load its user interface on web browsers so with Flash EOL in place, 4.x user interfaces will not load.

As flash is being permanently removed, any browser supporting flash is also removing its support.

Firefox flash plugin failed to load